Just like the hanging magnet is pulling on the car, the car magnet is also pulling on the hanging apparatus. Unfortunately for the car, the apparatus is attached to it, so it all cancels out.

Maybe it’s natural selection 🤔 everyone who could do it was just like 👍 yep I’m good 👍 and never had any kids.

If your weight increased to 20x your current weight, without changing proportions, you would be about 2.7x your current height, width, and depth.

…just like OP’s mum.

Gotcha – yeah I can confirm the thermocoil (at least in the BBP) isn’t very stable. If you don’t care about simultaneous steaming & brewing, to get good stability you could go for a single boiler machine with PID like the Profitec Go, Lelit Victoria, or Ascaso Steel Uno. Note the PID is important – it’s basically a smart controller to avoid the boiler overshooting the target temperature, so you get much better consistency.

In addition to measuring your output / a longer extraction, you can try a longer pre-infusion, or bumping up the temperature. 190F is on the very low end of what is usually considered ideal – you could try aiming for 195 - 205. Also, if the portafilter is not fully heated that will offset the brew temperature and cause lower extraction.

Are you using the Stilosa stock, or do you have a bottomless portafilter etc.? How long have you had it?

For me, I wouldn’t have wanted to upgrade to the Elizabeth directly. After the Stilosa I moved to a Breville Bambino Plus. That solved my biggest issues with the Stilosa (lack of temperature stability and a crappy steam wand), and let me get a bottomless pf and unpressurized basket and learn how to get really good puck prep and dial in by taste. Plus the steam wand was good enough to really learn latte art.

My main reasons for the upgrade to the Elizabeth are to have more fine-grained control over temperature, pressure, etc. for better shot consistency and control when dialing in, plus an even better steam wand. But back when I had the Stilosa, personally I wouldn’t have known what to do with that level of control. Obviously your experience may differ, but I wouldn’t change my choice of the BBP as the second step on my espresso journey.

Bambino Plus gang 💪

The Go looks like a good machine. A dual boiler was important to me because I make a lot of milk drinks so being able to steam milk while the temperature stabilizes for the next shot is really nice. Other than that my requirements were temperature control and a relatively small footprint (though I have to say, upgrading from the Bambino Plus to the Elizabeth was still quite a shock as far as the size difference)

Will I use it? Absolutely not.

Do I hope that it gets used by others? Yeah, at least a bit. Because if Meta assigns more engineers to work on fedi tech like improving ActivityPub that would be a huge win for the fediverse in general. That assumes they actually contribute to open source, but Meta/FB actually has a reasonable track record there.

I think you misplaced the apostrophe. If you think it’s just going to be one American I have some news for you.

Does this point to an inherent problem with the federated approach; i.e. that every instance has to be able to handle the load of the content on all other instances it federates with?

Pardon if I’m misunderstanding something. But it seems like a big barrier to entry for new instances if e.g. an instance with 100 users has to sync the contents from 100,000 other users to work properly. As the fediverse keeps growing and the requirements to host instances keep increasing, won’t it end up where only a few instances have the money / resources to handle the load?