I’m trying to build a esp8266 weather station and got some MCP1700-3302E to power the esp8266 from a lipo. But when I connect the lipo to the MCP1700 (looking at it flat spot at the front, ground left, Vin in the middle and Vout on the right) I get no output at Vout. I googled and could not find anything. I tested 5 different ones and it’s the same for all of them. Could I just have a batch of broken ones? Edit: attached a picture of my very simple test setup
The “typical application circuits” on page 2 in the datasheet https://ww1.microchip.com/downloads/en/DeviceDoc/MCP1700-Data-Sheet-20001826F.pdf shows both input and output being decoupled with a 1µF cap, have you tried that? I haven’t worked with the MCP1700, but I have had other LDOs fry themselves because the decoupling malfunctioned.
I initially tried with those capacitors but decided to also try without them - perhaps you’re right and I broke my LDOs by doing that :/
I’m not saying that your LDOs are fried. What I am saying is that some LDOs don’t take too kindly on not having the company of some nice caps.
What just caught my eye is that the datasheet specifies ceramic non-polar caps. That seems a bit weird. Just drawing a non-polar would have made sense, but specifying that it is a ceramic is strange. Using a ceramic makes sense, I mean there are 5 times the ceramic 1uF caps on digikey than there are electrolytics, but it should be technologically agnostic… I’d probably try to get some 1uF ceramics for testing.