Prints started to get all wonky about a week ago. I couldn’t figure out the problem. Changed the nozzle, tighten the belts, lubed the z screws, and cleaned the carbon fiber rods. Disassembled the extruder and I didn’t see any clogging, but when I disassembled the hall sensor, I noticed a lot of wear. Then I found a piece of metal inside the extruder that I suspect broke off from the hall sensor somehow. A new extruder arrived yesterday and the X1C is printing like a champ again.

  • GodzillaSpark@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I noticed that towards the last couple of hundred hours it started to clog/jam a lot more. I thought the gears might be wearing but it looked ok upon visual inspection. I wonder it’s an early warning sign. I only print PLA and PLA+ so nothing abrasive.

    • CmdrShepard@lemmy.one
      link
      fedilink
      English
      arrow-up
      0
      ·
      1 year ago

      What are the replacement costs for this? I’ve heard that Bambu uses all proprietary parts so there’s no buying Chinese knockoffs at a discount.

      • GodzillaSpark@lemmy.worldOP
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        $45. I’m 100% ok with spending $45 after 3000 hours. So far I feel I’m getting good value for my money both with the printer and the parts.