I can’t remember if I reloaded a previous save or fast traveled out of there, but there is a way to heal down there I believe

deleted by creator

I’ve had under extrusion, caused by too high speed or pressure advance settings look like this, does it show up if you slow down?

One I don’t see people mentioning is the walking dead saints and sinners. I haven’t played part 2 yet but I put a lot of hours into the first one

That last point is a big one, for me putting 30 hours into a single VR game feels like putting 100 into a pancake.

I had similar problems on my sidewinder x1 that had two lead screws, honestly I would recommend skipping the v rollers completely and go straight to something with linear rails or modding some on

I second every bit of this. My first printer was a sidewinder I upgraded like crazy and converter to klipper. Ended up just wishing I started with a corexy. Mine had a bit of a bend in the x gantry that took me forever to figure out and was not possible to compensate for. Went to a 300mm voron 2.4 afterward and have been super happy