Correct, not self-hosted. The advantage is it comes with a book reading community :-)

I’ve been using hardcover for a few months…great vibe, active development.

Lots of mentions for Obsidian. I’ll throw in my favorite for the past few years that’s similar: Logseq! Check it out!

Nice…I use Logseq, quite similar.

I’ve always held high hopes (albeit uninformed hopes) for carbon capture… Thanks for the links, looking forward to reading them.

I have to rent out my basement, otherwise I literally couldn’t afford my house plus food for my family of 4 (single income). We’re living pay cheque to pay cheque, so I feel a certain amount of “fuck you” to this (assuming) sarcastic post.

Fantastic, thank you 🙂

Wow that worked like a charm, thanks for that. Kobo Aura 2 H2O edition 2, for the record

The Knowledge Project with Shane Parrish

Thanks for that link. I wouldn’t be surprised if this is my issue. I replaced a nozzle very recently and it seemed to improve things, but it quickly degraded. I also replwced the PTFE tube and likely did it wrong…though the symptoms existed before I replaced the tube. I also have a fan that has been on its way out for a while, so I could be getting heat creep. It could be a combo of all things. Either way, I have new fans on order and will be doing the rebuild. Thanks!

agh - I miss-clicked on edit and hit delete…I hope this repost doesn’t mess with something or someone. Sorry!

That’s a great article, thanks for the link. I had a suspicion that a ripple texture between lines is an indicator of too low, but it’s good to get that affirmation. I usually do a real-time final cal when it’s printing the skirt (micro up/down)

Usually just got water and soap.

I gotta say a big thank you to everyone that responded. Your encouragement for me to take a breather and regroup with a cool head was much needed. Thank you all kind strangers :-)

Someone else mentioned a G10 printing surface. Any idea what’s better for PLA? Or what’s the difference between the two?

Gahhhh same thing… I’m on day 4 of this bs. I’m gonna throw my printer out a window

ok ok, I’ll put the old bed on after I wash it real good…I do this periodically but maybe I was eating chips or something.

I’ve tried raising and lowering the z-offset…higher just makes it more angry and lower doesn’t get to the point that it fixes it

I’ve heard of using gluestick…but dang it sounds messy. Do you have a link to the stuff you tried?

I forgot that I had a spare glass bed, still in box…I put it on and tried the same print with the same results…the curl!! I tried printing at both 190 and 200 on the head, 55 and 60 on the bed…still the same.