1·
4 months agodeleted by creator
- 0 Posts
- 2 Comments
Joined 1 year ago
Cake day: October 13th, 2023
You are not logged in. If you use a Fediverse account that is able to follow users, you can follow this user.
-
touch the tip of the solder where the iron meets the pad or the pin
-
try to get as much contact with both the pad as the pin as you can
-
the pad could be dirty or not hot enough. Especially when the pad is connected to a ground or power plane layer in the PCB it may take longer than expected to reach a sufficient temperature. Usually adding some flux helps remove any dirt.
-
Yea you are? Sprinters or Crafters easily fit a stack of sheets, at least in the EU they do