Tendon after 6 or so hours simmering or 1 hour in a pressure cooker and you got my favorite pho add in.
Tendon after 6 or so hours simmering or 1 hour in a pressure cooker and you got my favorite pho add in.
It’s the “feijoa, or pineapple guava”, apparently.
Did you freehand the cuts or use the chopsticks/skewers assisted method?
Just opposite of the current position. Would only apply to views where thumbnails can be on one side of course (small, smaller, compact)
It would be nice to have a quick action to change thumbnails to the opposite side.
Only the headphone jack crackle issue mentioned.
Possibly some kind of taffy sort of candy
Even the steam deck’s touch pads could be moved up more imo however, these look to be pretty much unusable.
Does Dvorak count? I switched over when I made an egrodox style keyboard which in itself made typing generally more comfortable.
+1 for display fusion.
Don’t rule out the wire behind the dash. I was experiencing similar behavior until my phone just didn’t connect but still was getting power from the port. Turns out the wire connecting the USB port and the head unit was faulty. If I wiggled the wire on the end connected to the head unit then it worked like normal.
Also do software. Went from a triple monitor (1080 portrait, 1440 landscape, 1080 portrait) to super ultra wide. The biggest reason was my work laptop only supports two 1440 or one 4k monitors so I use the ultra wide in picture by picture mode.
I miss the vertical space for reading documents but that’s kind of it. There is enough horizontal space to have my work open with slack/email/whatever on the side since it’s basically two monitors but without the bezel.
I’ve been enjoying the ultra wide way more when gaming vs the single 1440, by a lot. Don’t think I could go back now however I play a lot of fps games that will use the whole monitor.
The only annoying thing is I need to switch to input mode whenever I switch computers but this might not apply to you if all devices can support the native resolution.
It’s just more due to the size and it being a mostly flat print makes it ideal for fdm.
deleted by creator
Your current plan is solid. Print the plate with fdm, though it can’t be too thin. There are a few designs on thingiverse and etc. to get an idea on how thick.
Flex seal or nothing.
Food Wishes is the GOAT.
Please provide measurements.
No, comparisons should be of relative price and performance class not naming conventions.
Better than dry crust.