• 0 Posts
  • 7 Comments
Joined 1 year ago
cake
Cake day: July 15th, 2023

help-circle
  • I have the Plex Docker container running on Unraid. The plex container has its own WD Blue NVMe for storage.

    CPU: i3-9100 (Quicksync Enabled) RAM: 32GB DDR4 ECC Motherboard: Dell Precision 3630 Motherboard Storage: around 80TB using Unraid with 1 parity disk

    Seems to work reasonably well for our 8 users, and all things considered was relatively cheap for hardware other than disks, which I got most of from the ServerBuilds forum group buy awhile back.

    I moved to this from a dual Xeon setup in order to lower power consumption and enable quick sync. The dell motherboard works well but does require jumpers on some pins to boot that seems to be a craps shoot on eBay whether they are included or not, as well as a proprietary power button unless you’re okay with ignoring a boot warning.


  • The problem with these older units is that we have come so far in terms of performance per watt that the cost of electricity quickly makes them irrelevant.

    I used to run a cluster of Dell 710s that I was able to replace with a few M720q very cheaply off eBay and run the same workloads at less than 1/3 the power usage (even better at idle, since that really where these old units don’t do well).

    I have seen a few converted into DAS or drawers for a rack, but you’d have to already have a rack for that to be useful or worthwhile.




  • Welcome, doing the same myself. I wasn’t much of a contributor prior to the great migration and I’m trying to step up my contributions in order to help grow things.

    Personally my entry into Home Assistant and Smarthome was to fix a very strange series of light switches in my house that all turned on or off different lights in 1 area and I used a series of smart switches, smart bulbs and lighting groups to make them all controlled as if they were on circuit, as the cost to do so electrically was prohibitive.

    Now my automations are mostly to check on the state of the house and report problems. Such as if the door to the laundry room is left closed too long (as the litterbox is in there) and to check on the state of battery powered devices to see if batteries need replaced.

    I try to keep the automations simple and unobtrusive.


  • I have been using a variety of Zooz switches going on 2 years now. The earlier 20 series switches were personally my favorite since the they have a very distinct click and the new 70 series are softer.

    As far as reliability they’ve actually been perfect in talking to both a Nortek Combo dongle and the new Zooz 800 series stick directly on home assistant. Now there are a few caveats:

    1. I’ve had terrible luck with Zooz Relays, I cannot keep the things in sync with HA and I’ve been too busy to troubleshoot it further. I can’t recommend these at this time.

    2. Zooz dimmers can be picky about the LED bulbs you use, I would advise avoiding dimmers or only getting 1 dimmer to test the bulbs you plan on using. You may get bulbs that are “dimmable” but then end up flickering regardless of being “anti flicker”, and the lowest sim setting IMO isn’t that dim. The only bulbs I have that work well were a clearance bulb from a local hardware store and they no longer stock them so if I end up replacing them in the future I may swap from Dimmers to Smart Bulbs + Smart Switches

    3. I had one that was DOA but Zooz support sent a replacement in just a couple of days, so support was reasonable.