• jet@hackertalks.com
    link
    fedilink
    English
    arrow-up
    74
    arrow-down
    1
    ·
    edit-2
    6 months ago

    When you’re done soldering, cover the soldering iron tip in solder, and store it covered in solder. This prevents it from oxidizing when you’re not using it

    • weeeeum@lemmy.world
      link
      fedilink
      English
      arrow-up
      6
      ·
      6 months ago

      I solder for work and I cover my tip every time I put it down. Never ever needed to use tip tinner. Also never had to replace a tip either.

        • bl_r@lemmy.dbzer0.com
          link
          fedilink
          English
          arrow-up
          4
          ·
          6 months ago

          When I say explode, I mean the tip shot bits in a 1-2 inch radius after I put pressure on a thick copper wire. It nearly hit my non-dominant hand which was holding the circuit board on the floor tile I used to isolate my soldering shit from the now singed table

          • Empricorn@feddit.nl
            link
            fedilink
            English
            arrow-up
            3
            ·
            6 months ago

            If you’re trying to make me less terrified of soldering now, it’s not working.

            • bl_r@lemmy.dbzer0.com
              link
              fedilink
              English
              arrow-up
              2
              ·
              6 months ago

              Would it help you to know it was the soldering iron my dad got when he finished his electrician apprenticeship in the early 80s, which was probably a decade old at that point

          • jet@hackertalks.com
            link
            fedilink
            English
            arrow-up
            2
            ·
            6 months ago

            This kind of sounds like whatever was on the tip had oxidized severely over the intervening 40 years. So when you applied heat it couldn’t conduct very well, so it got hotter and hotter until it had an uncontrolled thermal expansion. This just comes down to especially with older equipment, making sure the device is clean, and if you apply heat be careful especially on the first startup.