• blitzen@lemmy.ca
    link
    fedilink
    English
    arrow-up
    1
    arrow-down
    1
    ·
    60 分钟前

    No-one is going to comment on the outlet being installed upside down?

  • ki4jgt@feddit.org
    link
    fedilink
    arrow-up
    1
    ·
    2 小时前

    Electricity flows over metal, not through it. As long as there’s an insulator on top, there shouldn’t be an issue.

    Would I try it? No.

    Could it work? Yes.

    • zemo@lemmy.world
      link
      fedilink
      arrow-up
      1
      ·
      11 分钟前

      I assume the metal hanger is aluminium. Unless you competely cover the metal in an insulator at the outlet legs then this will short and trip a fuse the second it is plugged in.

    • DarkCloud@lemmy.world
      link
      fedilink
      arrow-up
      1
      ·
      44 分钟前

      Bismuth or Tungsten are very low in electrical conductivity. Coat them in clear rubber and it should be a long while before there’s a short.

    • MortUS@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 小时前

      Electricity flows over metal, not through it.

      I don’t think that’s true, but I don’t know enough about electricity to refute it. electromagnetism, sure, but as long as the metal loops around it’ll pull in the electricity (I believe).

    • NotAnOtter@lemmus.org
      link
      fedilink
      English
      arrow-up
      9
      ·
      7 小时前

      Well if it was real they would have realized the mistake the moment they plugged it in. Since it’s plugged in for the picture, we know they are doing satire

  • Yakuza_Wolf_ReRise@thelemmy.club
    link
    fedilink
    arrow-up
    11
    ·
    8 小时前

    Honestly, if it was plastic & around the block instead of the outlet, then that’ll be a pretty good idea. Plus, we have 3-D printers, so it should be easy

  • UnityDevice@lemmy.zip
    link
    fedilink
    English
    arrow-up
    20
    arrow-down
    2
    ·
    15 小时前

    Every time I see US sockets, I get the heebie jeebies. Or any non-recessed socket really, but at least most add insulation to the base of the prongs. No such luck here.

    • Bluewing@lemmy.world
      link
      fedilink
      arrow-up
      6
      arrow-down
      2
      ·
      11 小时前

      Meh, that’s only going to “coulda killed you”. The one piece metal wire will create a dead short across the circuit and trip it out instantly. He IS going to need new underwear and possibly pants also. He’ll have some scorched fingers with maybe a bit of temporary tingling in them after pissing off the angry pixies. But as far as death goes, god would need to be looking down directly at him and go “Fuck this guy, right now”. Not impossible, but it would require an exceptional amount of bad luck.

      US outlets are safe. Not only does this out show a bit of recess at the surface, but the metal contacts that are carrying the current are also recessed inside about 1/8"/3mm where you can’t see them.

      • hereiamagain@sh.itjust.works
        link
        fedilink
        arrow-up
        2
        ·
        2 小时前

        I dropped a penny into the gap between the plug and the socket when I was a toddler. The sparks were FANTASTIC, and long lasting, like a sparkler shooting up the wall.

        My dad tried to remove the penny with his metal pliers, my mom stopped him before he killed himself. She yanked the cord and it stopped.

        We saved the penny for awhile, might still be somewhere. It burned two trenches in the penny, it almost made it all the way through.

        Lessons were learned.

  • Etterra@discuss.online
    link
    fedilink
    English
    arrow-up
    9
    ·
    16 小时前

    Literally the only good thing that could be said about this is that it’s on a brick wall. Otherwise that’s now the 3rd most dangerous electrical outlet I’ve ever seen.

    • raspberriesareyummy@lemmy.world
      link
      fedilink
      arrow-up
      8
      arrow-down
      1
      ·
      16 小时前

      How so? This one instantly trips a circuit breaker and then is quite safe. Now if the two hooks were separate, ir’d be a whole different matter…

      • Etterra@discuss.online
        link
        fedilink
        English
        arrow-up
        5
        ·
        10 小时前

        2nd worst: at my friend’s last place the microwave mounted over the stove fell out and he had me come look and fix it and I discovered that the outlet that powered the microwave was strapped to the gas line. No box, just the wires out the end of the conduit wired into the outlet there inside the wall. I told him to get an electrician, I was not touching that shit.

        1st worst: basically looked like this.

  • technocrit@lemmy.dbzer0.com
    link
    fedilink
    arrow-up
    1
    arrow-down
    1
    ·
    9 小时前

    When I was in middle school, we would bend a paper clip so it fit in a socket, then wrap a rubber band around the “handle”, then plug it into a socket. The paperclip would make a small “explosion”, melt off in the socket, and sometimes blow the fuse. It was a fun but crazy form of science/vandalism…